HP 3PAR StoreServ Cluster Extension Software Administrator Guide

Importing configuration settings using the CLI
1. Open a command window.
2. Enter clx3PARconfig IMPORT /FILE=filepath, where filepath specifies the file
location and name.
Importing CLX configuration prior to version 3.02.00
If TPDNOCERTPROMPT environment variable is set, then remove the TPDNOCERTPROMPT
environment variable before starting HP 3PAR StoreServ Cluster Extension configuration tool. Once
the CLX configuration is complete, you can set the TPDNOCERTPROMPT environment variable
again. This can be performed if the 3PAR CLI and the 3PAR OS versions are either 3.1.2 MU3
P16, 3.1.1 MU3 P27, 2.3.1 MU5 P35, 3.1.3, or later.
If you are importing the CLX configuration that was created using a CLX version prior to 3.02.00,
then perform the following steps after the import operation is successful:
1. Launch the configuration tool. See “Starting the HP 3PAR StoreServ Cluster Extension
configuration tool” (page 20) for information on launching the CLX configuration tool.
2. For every array that is added to the CLX configuration tool, select the array and click Modify.
3. A new window is launched that displays the information about the currently added array as
shown.
28 Configuring HP 3PAR StoreServ Cluster Extension