HP 3PAR StoreServ Cluster Extension Software Administrator Guide (5697-2894, December 2013)

directory specified by the ApplicationDir resource property. If the resource is taken offline,
this file is deleted.
• Windows Server 2008 only: If a HP 3PAR StoreServ Cluster Extension resource is not
configured, the resource icon in the Failover Cluster Management GUI shows the message
not configured next to the resource status.
• The HP 3PAR StoreServ Cluster Extension resource must be the first resource for all other disk
resources.
• The resource's PendingTimeout value must be equal to or greater than the value specified
for the ResyncWaitTimeout attribute.
Setting Microsoft cluster-specific resource and service or application
properties
Microsoft allows you to set specific failover parameter and threshold values for a service or
application, and for a resource. Some of these values must be changed for HP 3PAR StoreServ
Cluster Extension to enable manual recovery actions in case of a disaster.
To set Microsoft cluster-specific resource properties:
• For Windows Server 2008/2008 R2/2012, use the Failover Cluster Management GUI or
cluster commands in the CLI or use PowerShell Cmdlets.
• For Server Core or Hyper-V Server, use cluster commands in the CLI or use PowerShell Cmdlets.
TIP:
You can use the GUI option for Server Core or Hyper-V Server by using the MMC to manage a
cluster remotely. For more information about using the MMC, see your Microsoft documentation.
HP 3PAR StoreServ Cluster Extension requirements for Failover Cluster Management resource
properties are described in Table 1 (page 32). If there is no required value for a property, the
valid and/or default values are specified. Set these properties in the resource properties window
or the CLI. If you use the CLI, use the following command:
cluster.exe resource <ResourceName> /prop PropertyName="PropertyValue".
For PowerShell, use the following command:
Get-ClusterResource "Resource_name" | Set-ClusterParameter -Name
"property_name" -Value "value_to_set"
For more information about setting resource properties, see your Microsoft documentation.
Setting Microsoft cluster-specific resource and service or application properties 31