HP 3PAR StoreServ Cluster Extension Software Administrator Guide (5697-2442, July 2013)

Table 1 Setting resource properties and values in the GUI (continued)
ValueDescriptionFormatProperty
properties window in
Failover Cluster
Management.
Check (Required)Defines whether resources
will be failed over if a restart
is unsuccessful.
IntegerIf restart is unsuccessful, fail
over all resources in this
service or application
CLI: 2 restart and
affect the group
(Required)
Set this value in the Policies
tab of the resource
RestartAction (CLI)
properties window in
Failover Cluster
Management.
GUI: 15:00 mm:ss (Default)Determines the amount of
time for restart.
IntegerIf a resource fails, attempt
restart on current node –
Period for restarts
CLI: 900000 milliseconds
(Default)
Set this value in the Policies
tab of the resourceRestartPeriod (CLI)
properties window in
Failover Cluster
Management.
GUI: 03:00 mm:ssUsed to specify the timeout
for status resolution. For
IntegerPending timeout (GUI)
PendingTimeout (CLI)
CLI: 180000 milliseconds
(Default)
more information, see
“Timing considerations for
Windows Clustering
(MSFC)” (page 43).
Set this value in the Policies
tab of the resource
properties window in
Failover Cluster
Management.
HP 3PAR StoreServ Cluster Extension requirements for service or application properties are described
in Table 2 (page 29). If no specific value is required, the default value is listed. Set these values
in the Failover tab of the service or application properties window or in the CLI. For more information
about setting service or application properties, see your Microsoft documentation.
TIP: To change the properties in Table 2 (page 29) with the CLI, use the following command:
cluster group groupname /prop propertyname="propertyvalue".
For PowerShell, use the following command:
Get-ClusterResource "Resource_name" | Set-ClusterParameter -Name
"property_name" -Value "vale_to_set"
28 Configuring HP 3PAR StoreServ Cluster Extension