HP 3PAR Cluster Extension Software Administrator Guide (5697-2047, June 2012)

Table 2 Service or application properties and values
ValueDescriptionFormatProperty
GUI: Prevent failback
CLI: 0 (required)
Prevents automatic failback
of a service or application
IntegerGUI: Failback (Prevent
failback or Allow failback)
to its primary system.
CLI: AutoFailbackType
Transfer the service or
application back manually
after the failure has been
recovered. This allows
recovery of all possible
failure sources and pair
resynchronization (if
necessary) while the
application service is still
running.
6 (Default)Determines the time (in
hours) over which the cluster
StringGUI: Period
CLI: FailoverPeriod
6 (Default) service attempts
to failover a service or
application. See “Timing
considerations for Windows
Clustering” (page 36) for
more information.
Windows Server
2008/2008 R2: Number of
nodes in the cluster minus 1.
Determines the number of
failover attempts. In case of
subsequent system failure,
the default value allows
IntegerGUI: Maximum failures in
the specified period
(Windows Server
2008/2008 R2), Threshold
(Windows Server 2003)
Windows Server 2003, CLI:
10 (Default)
cluster service to transfer the
service or application to
CLI: FailoverThreshold
each system. If all cluster
systems are not members of
the cluster, the service or
application might restart
automatically.
If this value is set to a
number higher than the
current number of clustered
systems for the cluster group,
the service or application
will continue to restart until
either the FailoverThreshold
value or the FailoverPeriod
timeout value is reached.
Setting HP 3PAR Cluster Extension-specific resource properties
Changes to resource properties take effect when the resource is brought online again. For instructions
on changing resource properties, see:
• “Setting HP 3PAR Cluster Extension resource properties using the GUI” (page 31)
• “Setting HP 3PAR Cluster Extension resource properties using the MMC ” (page 36)
• “Setting HP 3PAR Cluster Extension resource properties using the CLI” (page 36)
• “Setting HP 3PAR Cluster Extension properties using a UCF” (page 37)
Setting HP 3PAR Cluster Extension resource properties using the GUI
This section describes the procedures for setting HP 3PAR Cluster Extension resource properties
with a GUI. You can perform these procedures through the resource configuration utility using the
cluster software GUI (Cluster Administrator for Windows Server 2003 and Failover Cluster
Setting HP 3PAR Cluster Extension-specific resource properties 31