HP 3PAR Cluster Extension Software Administrator Guide (5697-2047, June 2012)

Table 1 Setting resource properties and values in the GUI (continued)
ValueDescriptionFormatProperty
Windows Server
2008/2008 R2: 15:00
mm:ss (Default)
Determines the amount of
time for restart.
Set this value in the Policies
tab of the resource
IntegerIf a resource fails, attempt
restart on current node –
Period for restarts (Windows
Server 2008/2008 R2)
RestartPeriod (Windows
Server 2003)
Windows Server 2003: 900
seconds (Default)
CLI: 900000 milliseconds
(Default)
properties window in
Failover Cluster
Management, or in the
Advanced tab of the
RestartPeriod (CLI)
resource properties window
in Cluster Administrator.
Windows Server
2008/2008 R2: 03:00
mm:ss
Used to specify the timeout
for status resolution. For
more information, see
“Timing considerations for
IntegerPending timeout (GUI)
PendingTimeout (CLI)
Windows Server 2003: 180
seconds (Default)
Windows Clustering” (page
36) .
CLI: 180000 milliseconds
(Default)
Set this value in the Policies
tab of the resource
properties window in
Failover Cluster
Management, or in the
Advanced tab of the
resource properties window
in Cluster Administrator.
HP 3PAR Cluster Extension requirements for service or application properties are described in
Table 2 (page 31). If no specific value is required, the default value is listed. Set these values in
the Failover tab of the service or application properties window (Windows Server 2008/2008
R2), the resource group properties window (Windows Server 2003), or in the CLI. For more
information about setting service or application properties, see your Microsoft documentation.
TIP: To change the properties in Table 2 (page 31) with the CLI, use the following command:
cluster group groupname /prop propertyname="propertyvalue".
30 Configuring HP 3PAR Cluster Extension for Windows