HP 3PAR Cluster Extension Software Administrator Guide (5697-1429, March 2012)

HP3PARCLICommandTimeout
Format Integer
Description Specifies timeout value (in seconds) for HP 3PAR storage system command execution.
The timeout value is used whenever HP 3PAR Cluster Extension communicates with
the HP 3PAR storage system. If the storage system is not responding within the
configured timeout value, the command will time out and returns an error to the
application.
Default
value
90 seconds
Sample configuration file
The following is a sample UCF.cfg file:
COMMON
#LogLevel info # error|info default: error (optional)
#HP3PARCLICommandTimeout 60
# The APPLICATION part defines failover information for the application specified
# as value of the APPLICATION tag. For example, the command - clx3PARrun CLXSer -
# will use the below settings to check and allow access to the disk set specified
# as volume Group CLX_VG.
# Necessary object when clx3PARrun is used are:
# APPLICATION, DC_A_InServStorage_SerNum, DC_B_InServStorage_SerNum,
#RCVolumeGroupA, RCVolumeGroupB, DC_A_Hosts and DC_B_Hosts
APPLICATION CLXSer # package/service/cluster group test_application
DC_A_InServStorage_SerNum 1302871 # 1302871 is the data center A HP 3PAR
array serial number
#DC_B_InServStorage_SerNum 1302835 # 1302835 is the data center B HP 3PAR
array serial number
#RCVolumeGroupA CLX_VG # CLX_VG is the data center A HP
3PAR Remote Copy volume group name
#RCVolumeGroupB CLX_VG.r2835 # CLX_VG.r2835 is the data
center B HP 3PAR Remote Copy volume group name
#DC_A_Hosts clx_node1 clx_node2 # clx_node1, clx_node2 are data centre A cluster
nodes
#DC_B_Hosts clx_node3 clx_node4 # clx_node3, clx_node4 are data centre B cluster
nodes
#ApplicationStartup resyncwait # values: fastfailback | resyncwait # Setting the
fastfailback property will behave as resyncwait property when clx3parrun is used
#UseNonCurrentDataOk yes # values: yes | no #Default value is yes which causes the
failover operation to succeed at the destination site when the data at the
destination site might not be current. On setting the value to No the resource
will not come online at the destination site since the data might not be current.
NOTE: When you configure a UCF file, remove the # symbol for the properties you want to
configure.
Sample configuration file 67