HP CD-Writer Plus User's Guide - Not Orderable

Installation Notes

Read the Installation Poster

The Quick-Start installation poster describes how to install your CD-

Writer Plus drive. Follow the instructions on the poster and refer to this

chapter of the User’s Guide if you need additional information about:

■

How to set the CD-Writer Plus as Master or Slave

■

How to find the IDE connectors on your computer

■

How to connect the IDE data cable

■

How to connect an audio cable

How to Set the CD-Writer Plus as

Master or Slave

When you place Software Disc 1 in your CD-ROM and click Install CD-

Writer Plus the software analyzes your computer and makes a

recommendation about connecting the CD-Writer Plus hardware.

The Install Recommendation tells you whether the jumper on the CD-

Writer Plus should be set as Master or Slave for your computer.

Find the pairs of pins labeled Master, Slave, and Cable Select on the back

of the CD-Writer Plus. Notice that one pair of pins has a small plastic cap

or jumper. This jumper can be pulled off using your fingers, tweezers, or

needlenose pliers, and placed on a different pair of pins to change the

setting.