Connecting Your HP SureStore CD-Writer Plus Drive - C4358-90100
11
Installing the Software
After the CD-Writer drive is attached to your computer, you are
ready to install the application software.
NOTE: You must run the installation program. The installation
program converts the files from the Software Installation CD into a
usable format.
1. Insert the CD labeled Software Installation into your CD-ROM
drive (not the CD-Writer drive), if you have not already done so.
If your computer DOES NOT have a CD-ROM drive
To get your CD-Writer started right away, insert the diskette
labeled Driver Installation into your floppy drive.
■
Click the Start button on the task bar, select Run.
■
Type A:\SETUP (where A: is your floppy drives letter),
and press Enter.
■
The parallel port driver files are installed. This may take
several minutes and your mouse cursor will not move.
(Windows NT only: Reboot your computer before continuing.)
Now insert the CD labeled Software Installation into your
new CD-Writer drive and proceed with step 2.
NOTE: For information about inserting a CD into the CD-Writer
drive, see "Inserting a CD" on page 20.