UserÆs Guide and Technical UserÆs Guide - HP Carrier Grade Server cc3300

HP cc3300 Carrier Grade Server Product Guide
80 Upgrading the Hardware
Installing or Removing a Terminator
1. Observe the safety and ESD precautions at the beginning of this chapter and the additional
cautions given here.
2. Raise the locking bar (B in Figure 22) on the socket (A in Figure 22).
3. Align the corner marks on the terminator (C in Figure 22) along the locking bar side of the
processor socket.
4. Place the terminator into the socket.
5. Lower the locking bar (D in Figure 22) until it latches to the side of the processor socket.
6. Perform these steps in reverse to remove the terminator.
OM11787
A
B
D
C
Figure 22. Installing a Terminator