UserÆs Guide and Technical UserÆs Guide - HP Carrier Grade Server cc3300

HP cc3300 Carrier Grade Server Product Guide
vi Contents
Figures
Figure 1. cc3300 Carrier Grade Server Chassis........................................................................................13
Figure 2. Front Panel..................................................................................................................................16
Figure 3. Front View with Bezel Removed ...............................................................................................18
Figure 4. Back Panel DC Version, AC Version Shown at Right...............................................................19
Figure 5. Server Board Connector and Component Locations ..................................................................20
Figure 6. 5 Volt Riser Card........................................................................................................................29
Figure 7. 3.3 Volt Riser Card.....................................................................................................................29
Figure 8. Non-redundant AC-Power Supply Subsystem (Filler Module shown at Left)...........................31
Figure 9. Fan Array with Four System Fans Installed ...............................................................................35
Figure 10. Tools and Supplies Needed ......................................................................................................65
Figure 11. Unlocking and Removing the Power Supply Modules.............................................................66
Figure 12. Disconnecting the Hard Disk Drive Bay Cables ......................................................................67
Figure 13. Removing a Hard Disk Drive...................................................................................................68
Figure 14. Removing the Top Cover .........................................................................................................72
Figure 15. Internal Chassis Layout ............................................................................................................73
Figure 16. Installing DIMMs .....................................................................................................................74
Figure 17. Raising the Locking Bar and Removing the Terminator..........................................................76
Figure 18. Inserting the Processor and Lowering the Locking Bar ...........................................................77
Figure 19. Aligning the Heatsink and Installing the Heatsink Retaining Clip...........................................78
Figure 20. Unlatching the Heatsink Retaining Clip...................................................................................79
Figure 21. Raising the Locking Bar on the Processor Socket....................................................................79
Figure 22. Installing a Terminator .............................................................................................................80
Figure 23. Replacing 3.3 Volt or 5 Volt PCI Add-in Cards.......................................................................81
Figure 24. PCI Adapter Cable Installation.................................................................................................82
Figure 25. Replacing the Backup Battery..................................................................................................84
Figure 26. Removing the Peripheral Bay from the Chassis.......................................................................86
Figure 27. Front Panel Removal ................................................................................................................87
Figure 28. Replacing 80 mm Fans .............................................................................................................88
Figure 29. Replacing 40 mm Fans .............................................................................................................89
Figure 30. Removing the Power Supply Cage...........................................................................................90
Figure 31. 15-pin Alarms Connector .........................................................................................................93