UserÆs Guide and Technical UserÆs Guide - HP Carrier Grade Server cc2300

20 cc2300 Carrier Grade Server Product Guide
Processor
The server board accommodates one or two Intel Pentium III processors up to 1.26 GHz with
512k cache.
Memory
The system board contains six 168-pin DIMM slots each supporting 72-bit ECC (64-bit main
memory plus ECC) registered SDRAM DIMMs (PC-133 compatible). You may install a minimum
of 256 MB (128 MB x 2) and as much as 6 GB.
NOTE
DIMMs supplied have been tested for compatibility with the HP cc2300
Carrier Grade Server.
HP cc2300 Carrier Grade Server Memory Products
Product Number ECC SyncDRAM in module DIMM cards in module Height of DIMMs Server Used With
A6949A 256 MB Two cards (128 MB each) 30.5 mm (1.2") hp carrier grade server cc2300
A6932A 512 MB Two cards (256 MB each) 30.5 mm (1.2") hp carrier grade server cc2300
A6933A 1,024 MB Two cards (512 MB each) 30.5 mm (1.2") hp carrier grade server cc2300
A6934A 2,048 MB Two cards (1,024 MB each) 30.5 mm (1.2") hp carrier grade server cc2300
PCI Riser Slots
The server board has two PCI riser slots, each capable of supporting 64-bit/66-MHz PCI riser cards.
PCI features:
• Bus speed up to 66 MHz
• 32 bit memory addressing
• 5 V/3.3 V signaling environment
• Burst transfers of up to 512 Mbps
• 8, 16, 32, or 64-bit data transfers
• Plug and Play ready
• Parity enabled
Video
The server board uses an ATI RAGE
†
XL PCI graphics accelerator with 8 MB of video SDRAM
that supports all standard IBM VGA modes. The embedded SVGA video subsystem supports:
• Pixel resolutions up to 1600 x 1200 under 2D and 1024 x 768 under 3D
• CRT and LCD monitors up to 100 Hz vertical refresh rate
The server board supports disabling of the onboard video through the BIOS setup menu or when a
plug in video card is installed in any of the PCI slots.