User Information and Service Guide - HP Carrier-Grade Server cc3310

28 Chapter 2
Feature Description
Control access to
using the system
setup utility: set
administrator
password
To control access to setting or changing the system configuration, set an
administrator password and enable it through Setup.
If both the administrator and user passwords are enabled, either can be used to
boot the server or enable the keyboard and/or mouse, but only the administrator
password will allow setup to be changed.
To disable a password, change it to a blank entry or press CTRL+D in the Change
Password menu of the Administrator Password Option menu found in the Security
Subsystem group.
To clear the password if you cannot access setup, change the Clear Password
jumper (refer to Table 10-1).
Control access to the
system other than
system setup utility:
set user password
To control access to using the system, set a user password and enable it through
Setup.
To disable a password, change it to a blank entry or press CTRL+D in the Change
Password menu of the User Password Option menu found in the Security
Subsystem Group.
To clear the password if you cannot access setup, change the Clear Password
jumper (refer to Table 10-1).
Boot without
keyboard
The server can boot with or without a keyboard. During POST, before the server
completes the boot sequence, the BIOS automatically detects and tests the
keyboard if it is present and displays a message.
Specify the boot
sequence
The sequence that you specify in setup will determine the boot order. If secure
mode is enabled (a user password is set), you will be prompted for a password
before the server fully boots. If secure mode is enabled and the Secure Boot Mode
option is also enabled, the server will fully boot, but will require a password before
accepting any keyboard or mouse input.