- HP All-in-One Printer Manual

Q2431-90912 Chapter 3 Printer operation 51
Stapler/stacker submenu
This submenu allows you to select settings for the optional stapler/stacker, if one is installed.
Some items on this menu are available in the software program or the printer driver (if the
appropriate driver is installed).
The following section lists the settings and their possible values in the Stapler/stacker
submenu. The default value for each setting is the one that has an asterisk (*) next to it.
RAM DISK OFF
*AUTO
Use this item to configure the RAM disk.
OFF: The RAM disk is disabled.
AUTO: The printer determines the optimal RAM-disk size
based on the amount of available memory.
Note
If you change the setting from
OFF to AUTO, the printer
automatically reinitializes when it becomes idle.
LANGUAGE *ENGLISH
(Selections are
available
depending on
the installed
fonts.)
Selects the language for the messages that appear on
the printer control-panel display.
Table 25. Stapler stacker submenu
Item Values Explanation
STAPLER/STACKER
● STAPLES
● STAPLES OUT
● STAPLES
*NONE
ONE
Use this item to specify whether or not print jobs are
stapled.
NONE: Turns off stapling.
ONE: Turns on stapling.
Note
Selecting the stapler at the printer control panel
changes the default setting to staple. It is possible that
all print jobs will be stapled.
● STAPLES OUT
*STOP
CONTINUE
Use this item to tell the printer how to behave if the
stapler runs out of staples, as indicated by the STAPLER
OUT OF STAPLES message on the printer control-panel
display.
STOP: The printer stops printing until you refill the
stapler.
CONTINUE: The stapler accepts print jobs if it is out of
staples, but the pages will not be stapled.
For information about ordering a new staple cartridge,
see chapter 8.
Table 24. System setup submenu (continued)
Item Values Explanation