- HP All-in-One Printer Manual

Q2431-90912 Chapter 7 Troubleshooting 273
TRAY XX
<TYPE> <SIZE>
SIZE SPECIFIED BY USER
alternates with
TRAY XX
<TYPE> <SIZE>
TO CHANGE TYPE
PRESS
The printer is reporting the current
configuration of tray XX. The tray
switch is in the “custom” position.
1. To change the media type,
press the S
ELECT ()
button. Use the
U
P ARROW ( ) button and
the D
OWN ARROW ()
button to scroll to the type,
and then press the
S
ELECT button to select it.
2. To change the media size to
Letter, A4, Executive, B5 JIS,
A5, or Legal, set the tray
switch to the “standard”
position and adjust the media
guides to the correct
positions.
3. To change the media size to
other sizes, leave the tray
switch in the “custom”
position, adjust the media
guides against the media,
and close the tray.
4. Select the Paper Handling
menu from the control panel.
Configure the size and media
type for the tray.
UNABLE TO STORE JOB
<JOBNAME>
A job cannot be stored because of
a memory, disk, or configuration
problem.
1. Install additional memory in
the printer, or install a disk
drive in the printer. See
“Firmware DIMM” on
page 160.
2. If a disk drive is installed,
delete the previously stored
print jobs to increase the disk
storage space.
3. If this error persists, check
the printer driver and
application program settings.
USE INSTEAD?
TRAY X: <TYPE>
<SIZE>
The printer is offering the closest
selection of alternative media to
use for the print job.
To choose the alternative, press
the S
ELECT ( ) button. Use the
U
P ARROW ( ) button and
the D
OWN ARROW ( ) button to
scroll to any alternative selection,
and then press the S
ELECT ()
button to select it.
Table 41. Alphabetical printer messages (continued)
Message Description Action