- HP All-in-One Printer Manual

272 Troubleshooting Q2431-90912
TRAY XX
<TYPE> <SIZE>
TO CHANGE TYPE
PRESS
alternates with
TRAY XX
<TYPE> <SIZE>
SIZE DETECTED BY TRAY
The printer is reporting the current
configuration of tray XX. The tray
switch is in the “standard”
position.
1. To change the media type,
press the S
ELECT ()
button. Use the
U
P ARROW ( ) button and
the D
OWN ARROW ()
button to scroll to the type,
and then press the
S
ELECT ( ) button to select
it.
2. To change the media size to
Letter, A4, Executive, B5 JIS,
A5, or Legal, leave the tray
switch in the “standard”
position and adjust the media
guides to the correct
positions.
3. To change the media size to
other sizes, move the tray
switch to “custom”, adjust the
paper guides against the
paper, and close the tray.
4. Use the U
P ARROW ()
button and the
D
OWN ARROW ( ) button to
scroll to the media size, and
then press the S
ELECT ()
button to select it. Repeat this
procedure to select the media
type.
5. If the size that appears on the
control panel display is
incorrect and the tray paper
guides are properly adjusted,
verify that the indicated tray’s
media-size sensor (SW102,
SW801, or SW1) is
operating. See figure 213 on
page 336, figure 217 on page
340, or figure 220 on page
343. Verify that the sensor
“fingers” inside the tray are
engaging the tray sensor
correctly. See “Tray 2, 500-,
1,500-sheet feeder media
size detection” on page 83.
Table 41. Alphabetical printer messages (continued)
Message Description Action