- HP All-in-One Printer Manual

222 Removing and replacing parts Q2431-90912

1,500-sheet feeder lifter-drive assembly

1. Remove the following assemblies:

● Door. See “1,500-sheet feeder door” on page 215.

● Rear and right-side covers. See “1,500-sheet feeder rear cover” on page 217 and

“1,500-sheet feeder right-side cover” on page 218.

2. Unplug the lifter-drive harness connector from the PCA (location J1003; callout 1).

3. Unplug the lifter-drive sensor harness from the sensor (callout 2) and remove the sensor

harness from the wire clip (callout 3).

Figure 194. 1,500-sheet feeder lifter-drive assembly (1 of 4)