- HP All-in-One Printer Manual

214 Removing and replacing parts Q2431-90912

1,500-sheet feeder assembly

1,500-sheet feeder feed rollers

Note The removal procedure for the two paper-feed rollers that are located up inside of the 1,500-sheet

feeder is the same as the procedure for the tray 2 feed rollers. See “Tray 2 feed rollers” on

page 141.

1,500-sheet feeder separation roller

1. Open the 1,500-sheet feeder door. Open the feed roller cover.

Figure 181. 1,500-sheet feeder roller (1 of 2)

2. Pinch the blue latch that is on the side of the feed roller and slide the roller off of the shaft.

Figure 182. 1,500-sheet feeder roller (2 of 2)

Reinstall note This roller must lock into place. Verify that the roller is seated on the locking bars that are located

on the round black spacer and that the spacer is seated on the shaft-locking pin (callout 1 & 2).