- HP All-in-One Printer Manual

202 Removing and replacing parts Q2431-90912

4. Push the paper-feed and transfer assembly wire-harnesses through the hole in the chassis

(callout 5).

Reinstall note The plastic clip (callout 5) that lines the hole in the chassis protects the wire-harnesses from

chaffing on an exposed edge of the sheet-metal chassis. This clip can easily become dislodged

and lost. Make sure that this clip is installed when you replace the transfer assembly.

Figure 159. Transfer assembly (3 of 5)

5. On the left side, remove 16 screws (callout 6; 15 if the paper-feed assembly has been

removed).

Figure 160. Transfer assembly (4 of 5)