- HP All-in-One Printer Manual

Q2431-90912 Chapter 6 Removing and replacing parts 197
Reinstall note When the paper feed assembly is installed, the sensor-flag spring must be correctly positioned
for the flag to operate. If a paper-jam error message (13.20.00 JAM) appears on the control-panel
display after you replace the paper feed assembly, verify that this sensor-flag spring is installed
correctly.
Hook the spring over the flag tab (see 1 in Figure 153). Fasten the paper feed assembly to the
chassis with the flag spring positioned in the hole in the transfer assembly. Release the spring
from the tab on the flag (see 2 in Figure 153). See figure 153 below.
Verify that the flag is held in the upright position, can freely move, and always returns to the upright
position. If the flag does not move freely, or return to the upright position, an error
message (13.20.00 JAM)
will appear on the control-panel display when the printer power is turned
on.
Reinstall note Verify that the clutch tab on the right side of the paper feed assembly is inserted into the hole in
the plastic frame.
Hint The anti-static bar (see Cooling fan (right side; HP LaserJet 4300 series printer only) on
page 170) can be used to release the sensor spring.
Figure 153. Correctly install the paper-feed assembly sensor flag