- HP ProOne 600 G1 All-in-One Printer Manual

System board
Description Spare part number
System board for use in models without Windows 8 700629-001
System board for use in models with Windows 8 Standard 700629-501
System board for use in models with Windows 8 Professional 700629-601
The system board is located on the right side of the computer (viewed from the rear). It is secured with
eight Torx screws.
To remove the system board:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 33).
2. Remove the access panel (see
Access panel on page 37).
3. Remove the stand (see
Stand on page 39).
4. Remove the lower panel (see
Lower panel on page 42).
5. Remove the memory modules (see
Memory on page 50).
6. Remove the graphics heat sink (see
Graphics heat sink on page 61).
7. Remove the processor heat sink (see
Processor heat sink on page 62).
8. Remove the processor (see
Processor on page 64).
9. Remove the WLAN module (see
WLAN module on page 67).
10. Disconnect all cables from the system board, noting their location for reinstallation.
78 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis