- HP ProOne 600 G1 All-in-One Printer Manual

Memory
Description Spare part number
8-GB 689374-001
4-GB 689373-001
2-GB 689372-001
Memory modules are located on the right side of the computer (viewed from behind). The computer has
two memory slots that can be populated with up to two industry-standard SODIMMs. These memory
sockets are populated with at least one preinstalled SODIMM. To achieve the maximum memory
support, you can populate the system board with up to 16 GB of memory.
For proper system operation, the SODIMMs must be:
●
industry-standard 204-pin
●
unbuffered non-ECC PC3-10600 DDR3-1600 MHz-compliant
●
1.5 volt DDR3-SDRAM SODIMMs
The DDR3-SDRAM SODIMMs must also:
●
support CAS latency 11 DDR3 1600 MHz (11-11-11 timing)
●
contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification
In addition, the computer supports:
●
1-Gbit, 2-Gbit, and 4-Gbit non-ECC memory technologies
●
single-sided and double-sided SODIMMS
●
SODIMMs constructed with x8 and x16 SDRAMs; SODIMMs constructed with x4 SDRAMs are not
supported
NOTE: The system will not operate properly if you install unsupported SODIMM memory.
50 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis