- HP ProOne 600 G1 All-in-One Printer Manual

If you choose to install an optional 2.5-inch solid state drive (SSD) or self-encrypting drive (SED), you
will need a drive adapter. The drive adapter is not included in the 2.5-inch SSD spare parts kits.
The first hard drive data cable connects to the SATA0 and SATA PWR0 system board connectors.
The second hard drive data cable connects to the SATA1 and SATA PWR1 system board connectors.
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 33).
2. Remove the access panel (see
Access panel on page 37).
3. Pull the latch next to the lower side of the hard disc drive cage away from the cage to release it,
then slide the cage toward the edge of the chassis and lift it out.
46 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis