DC Input Module Installation Instructions - HP BladeSystem c7000 Enclosures

To ground the input module:
1. Unscrew the four captive screws on the front
of the module.
2. Slide the cover forward to disengage its
three top slots and lift upward.
3. Locate the ground nuts in the right and left
corners of the module.
4. Remove the ground nuts using a 3/8 inch
socket.
5. Place star washers on the ground
connections.
6. Secure the lugs on the grounding harness to
the input module with a lock washer and the
ground studs.
7. Attach the other end of the ground harness to
the grounding location specified in your rack
or enclosure documentation.
8. Replace the input module cover
Cabling the Input Module
To cable the input module for DC power:
1. Remove the terminal block nuts using a #11
or 7/16 inch socket.
2. Place star washers on the terminal block
connections.
3. Connect the return and -48V power wires to
the terminal block using a lock washer and
the terminal block nut. Follow the markings
on the DC input module for proper locations
of the -48V and RTN lines.
The installation is complete