Command Line Interface Reference Guide HP BladeSystem PC Blade Switch

5-6 www.hp.com HP PC Blade Switch CLI Reference Guide

Address Table Commands

bridge multicast forward-all

The bridge multicast forward-all Interface Configuration (VLAN) mode command enables

forwarding all multicast packets on a port. To restore the default configuration, use the no

form

of this

command.

Syntax

bridge multicast forward-all {add

| remove} {ethernet interface-list | port-channel

port-channel-number-list}

no bridge multicast forward-all

Parameters

n add — Force forwarding all multicast packets.

n remove — Do not force forwarding all multicast packets.

n interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces; a

hyphen is used to designate a range of ports.

n port-channel-number-list — Separate nonconsecutive port-channels with a comma and no

spaces; a hyphen is used to designate a range of port-channels.

Default Setting

This setting is disabled.

Command Mode

Interface Configuration (VLAN) mode

Command Usage

There are no user guidelines for this command.

Example

The following command configures the device to forward all multicast packets on port e8.

Console(config)# interface vlan 1

Console(config-if)# bridge multicast forward-all add ethernet