Command Line Interface Reference Guide HP BladeSystem PC Blade Switch

28-18 www.hp.com HP PC Blade Switch CLI Reference Guide
VLAN Commands
show interfaces switchport
The show interfaces switchport Privileged EXEC mode command displays the switchport
configuration.
Syntax
show interfaces switchport {ethernet interface | port-channel port-channel-number}
Parameters
n interface — A valid Ethernet port number.
n port-channel-number — A valid port-channel number.
Default Setting
This command has no default configuration.
Command Mode
Privileged EXEC mode
Command Usage
There are no user guidelines for this command.
Example
The following
command displays the switchport configuration for Ethernet port e1.
Console# show interface switchport ethernet e1
Port e1:
VLAN Membership mode: General
Operating parameters:
PVID: 1 (default)
Ingress Filtering: Enabled
Acceptable Frame Type: All
GVRP status: Enabled
Protected: Enabled, Uplink is e45.
Port e1 is member in:
VLAN Name Egress Rule Type
---- ------- ----------- -------
1 default untagged System
8 VLAN008 tagged Dynamic
11 VLAN011 tagged Static
19 IPv6 VLAN untagged Static
72 VLAN0072 untagged Static