Command Line Interface Reference Guide HP BladeSystem PC Blade Switch

HP PC Blade Switch CLI Reference Guide www.hp.com 22-7
Spanning-Tree Commands
spanning-tree disable
The spanning-tree disable Interface Configuration mode command disables spanning tree on a
specific port. To enable spanning tree on a port, use the no
form of this command.
Syntax
spanning-tree disable
no spanning-tree disable
Parameters
There are no parameters for this command.
Default Setting
Spanning tree is enabled on all ports.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
Command Usage
There are no user guidelines for this command.
Example
The following command disables spanning-tree on Ethernet port e42.
Console(config)# interface ethernet e42
Console(config-if)# spanning-tree disable