Command Line Interface Reference Guide HP BladeSystem PC Blade Switch

HP PC Blade Switch CLI Reference Guide www.hp.com 10-9
IGMP Snooping Commands
show ip igmp snooping groups
The show ip igmp snooping groups User EXEC mode command displays multicast groups
learned by IGMP snooping.
Syntax
show ip igmp snooping groups
[vlan vlan-id] [address ip-multicast-address]
Parameters
n vlan-id — VLAN number.
n ip-multicast-address — IP multicast address.
Default Setting
This command has no default configuration.
Command Mode
User EXEC mode
Command Usage
To see the full multicast address table (including static addresses) use the show bridge multicast
address-table Privileged EXEC command.
Example
The following command shows IGMP snooping information on multicast groups.
Console> show ip igmp snooping groups
VLA
N
IP Address Querier Ports
---- ----------------- ------- ----------
1 224-239.130|2.2.3 Yes e45
IGMP Reporters that are forbidden statically:
---------------------------------------------
VLA
N
IP Address Ports
---- ----------------- -----
2 224-239.130|2.2.3 e43