Command Line Interface Reference Guide HP BladeSystem PC Blade Switch

HP PC Blade Switch CLI Reference Guide www.hp.com 8-21
Ethernet Configuration Commands
port storm-control broadcast enable
The port storm-control broadcast enable Interface Configuration (Ethernet) mode command
enables broadcast storm control. To disable broadcast storm control, use the no
form of this
command.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Parameters
There are no parameters for this command.
Default Setting
Broadcast storm control is disabled.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode command,
to set the maximum allowable broadcast rate.
Example
The following command enables broadcast storm control on port e5 of a device.
Console(config)# interface ethernet e5
Console(config)# port storm-control broadcast enable