Command Line Interface Reference Guide HP BladeSystem PC Blade Switch

8-10 www.hp.com HP PC Blade Switch CLI Reference Guide
Ethernet Configuration Commands
back-pressure
The back-pressure Interface Configuration (Ethernet, port-channel) mode command enables
back pressure on a given interface. To disable back pressure, use the no
form of this command.
Syntax
back-pressure
no back-pressure
Parameters
There are no parameters for this command.
Default Setting
Back pressure is disabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
This feature is only available on ports operating in half-duplex.
Example
In the following example, back pressure is enabled on port e42.
Console(config)# interface ethernet e42
Console(config-if)# back-pressure