HP BladeSystem PC Blade Switch Installation Guide

To configure SNMP station IP address and community string(s), perform the following:
1. At the console prompt, type Enable.
The prompt is displayed as #.
2. Type configure and press Enter.
3. In configuration mode, type the SNMP configuration command with the parameters including
community name (private), community access right (read and write) and IP address, as shown in
the following example:
console> enable
console# configure
config(config)# snmp-server community private rw 192.168.1.2
config(config)# exit
console(config)# show snmp
Community-String Community-Access View Name IP address
------------------- ------------------- -------------------
private readWrite default 192.168.1.2
Community-String Group name IP address Type
Traps are enabled.
Authentication-failure trap is
enabled.
Version 1,2 notifications
Target address____ Type Community___ ____Version Udp_____Filter To_____Retries
___port_____name sec
----------------_____----- ------------_____------ ----_______----- --______--------
Version 3 notifications
Target address___Type Username_______Security Udp_____Filter To_____Retries
Level ____port_______name sec
----------------____--------- ------------_______------ ----_______----- --_______--------
SystemContact:
System Location:
ENWW Configuration Overview 19