Command Line Interface Reference Guide HP BladeSystem PC Blade Switch

4-6 www.hp.com HP PC Blade Switch CLI Reference Guide
ACL Commands
n dscp — Indicates matching the dscp number with the packet dscp value.
n ip-precedence — Indicates matching ip-precedence with the packet ip-precedence value.
Default Setting
This command has no default configuration.
Command Mode
IP-Access List Configuration mode
Command Usage
Use the ip access-lis
t Global Configuration mode command to enable the IP-Access List
Configuration mode.
Before an Access Control Element (ACE) is added to an ACL, all packets are permitted. After an
ACE is added, an implied deny-any-any condition exists at the end of the list and those packets
that do not match the defined conditions are denied.
Example
The following commands define a permit statement for an IP ACL.
Inter-Domain Routing Protocol idrp 45
Reservation Protocol rsvp 46
General Routing Encapsulation gre 47
Encapsulating Security Payload (50) esp 50
Authentication Header ah 51
ICMP for IPv6 ipv6-icmp 58
EIGRP rOuting Protocol eigrp 88
Open Shortest Path Protocol ospf 89
Protocol Independent Multicast pim 103
Layer Two Tunneling Protocol l2tp 115
ISIS over IPv4 isis 124
(any IP protocol) any (25504)
IP Protocol Abbreviated Name Protocol Number
Console(config)# ip access-list ip-acl1
Console(config-ip-al)# deny
rsvp 192.1.1.1 0.0.0.255 any