Command Line Interface Reference Guide HP BladeSystem PC Blade Switch

HP PC Blade Switch CLI Reference Guide www.hp.com 18-13
QoS Commands
service-policy
The service-policy Interface Configuration (Ethernet, port-channel) mode command applies a
policy map to the input of a particular interface. To detach a policy map from an interface, use
the no form of this command.
Syntax
service-policy {input policy-map-name}
no service-policy {input}
Parameters
n policy-map-name — Specifies the name of the policy map to be applied to the input
interface.
Default Setting
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, port-Channel) mode
Command Usage
Only one policy map per interface per direction is supported.
Example
The following command attaches a policy map called policy1 to the input interface.
Console(config-if)# service-policy input policy1