Command Line Interface Reference Guide HP BladeSystem PC Blade Switch

8-20 www.hp.com HP PC Blade Switch CLI Reference Guide
Ethernet Configuration Commands
port storm-control include-multicast (IC)
The port storm-control include-multicast Interface Configuration (Ethernet) mode command
counts multicast packets in broadcast storm control. To disable counting multicast packets, use
the no
form of this command.
Syntax
port storm-control include-multicast [unknown-unicast]
no port storm-control include-multicast
Parameters
n unknown-unicast — Specifies also counting unknown unicast packets.
Default Setting
Multicast packets are not counted.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
To control multicasts storms, use the port storm-control broadcast enable and port
storm-control broadcast rate commands.
Example
The following command enables counting broadcast and multicast packets on Ethernet port e42.
Console(config)# interface ethernet e42
Console(config-if)# port storm-control include-multicast