DCFM Migration and Transition Guide v10.0.1 (53-1001074-01, December 2008)

26 DCFM Migration and Transition Guide
53-1001074-01
1
18. Click Finish.
After all of the DCFM services are started, the Log In dialog box displays.
19. Enter your user ID and password in the User ID and Password fields.
If you are upgrading from a previous release, your user name and password do not change.
20. Click Login.
21. Click OK on the Login Banner.
Enterprise edition pre-installation requirements on UNIX systems
• To avoid errors, close all instances of the application before beginning the installation or
uninstallation procedures.
If you still receive error messages after closing the application, enter the following commands:
#ps -ef | grep -i “” to lists the process ID
#kill -9 “process ID”
• Check for and install the latest patches for your operating system. For the Solaris web site
listing patch information, go to http://java.sun.com/j2se/1.4.2/download.html.
• (Solaris only) To use IPv6 on a server that is IPv4 and IPv6 enabled, complete the following
steps.
a. Open a command window.
b. Type ifconfig <interface name> inet6 plumb up and press Enter.
c. Restart the SAN Management server and client, if running.
If the IPv6 address is not configured properly, the client will show a "Server Not Available at
port 51511" message even though the server started successfully.
• Make sure that an X Server is available for display and is configured to permit X Client
applications to display from the host on which they are installing the EFCM Server (typically,
this simply requires that the systems console be present and running with a logged in user on
the X Server based desktop session, such as KDE, GNOME, and so on).
If this is a headless unit with no console, refer to “Headless Pre-Installation Requirements” on
page 23.
• Make sure that the DISPLAY environment variable is correctly defined in the shell with a valid
value (for example, to display to the local console, export DISPLAY=:0.0, or to display to a
remote system that has an X Server running, export DISPLAY=remoteipaddress:0.0).
You may also need to consider a firewall that might block the display to the X Server which
listens by default on TCP port 6000 on the remote host.
To display to a remote system you need to permit the remote display of the X Server by running
command xhost +IP, where IP is the IP address of the EFCM server host from the X-based
desktop of the remote system.
• Make sure to test the DISPLAY definition by running the command xterm, from the same shell
from which you run install.bin. A new X terminal window to the destination X Server display
should open.