Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

908 Brocade Network Advisor SAN User Manual
53-1002696-01
SAN Historical performance data
29
Enabling historical performance collection SAN wide
To enable historical performance collection, select Monitor > Performance > Historical Data
Collection.
The Fabric Selector dialog box displays with Enable SAN Wide enabled by default. This enables
historical performance data collection for all fabrics in the SAN.
NOTE
After, enabling historical data collection information for switches, ports, and FCIP tunnels also
displays in the IP Historical Graph/Tables dialog box. If available, click the IP tab, then select Monitor
> Performance > Historical Graphs/Tables.
Enabling historical performance collection for selected fabrics
To enable historical performance collection for selected fabrics, complete the following steps.
1. Select Monitor > Performance > Historical Data Collection
The Fabric Selector dialog box displays.
2. Select Enable Selected.
The Historical Data Collection dialog box displays.
FIGURE 394 Historical Data Collection dialog box
3. Select the fabrics for which you want to collect historical performance data in the Available
table.
NOTE
Devices with 10GE ports must be running Fabric OS 6.4.1ltd or later to obtain the correct
TE port statistics (TX/RX).
NOTE
Devices with 10GE ports must have the rmon MIB enabled on the switch. For more information
about the rmon collection command, refer to the Fabric OS Converged Enhanced Ethernet
Command Reference.
4. Click the right arrow to move the selected fabrics to the Selected table.