Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

836 Brocade Network Advisor SAN User Manual
53-1002696-01
Saving or Copying Allow/Prohibit Matrix configurations to another device
25
Copying an Allow/Prohibit Matrix configuration
NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.
To duplicate an existing Allow/Prohibit Matrix configuration, complete the following steps.
1. Select Configure > Allow/Prohibit Matrix.
The Configure Allow/Prohibit Matrix dialog box displays.
2. Select the Allow/Prohibit Matrix configuration you want to copy.
You can do this by expanding the view for the switch under Available Switches and selecting a
configuration, or you may select the matrix under Allow/Prohibit Matrix.
3. Click Duplicate.
The Save As/Duplicate dialog box displays.
FIGURE 377 Save As/Duplicate dialog box
4. Enter a name for the configuration.
5. Enter a description for the configuration.
6. Select the check box for the switch to which you want to save the configuration in the Select
Switch table.
7. Cl ic k OK.
A message displays stating that the outstanding port configuration is discarded when copying
a configuration from the switch with more ports to a switch with fewer ports and vice versa.
Click OK to close the message.
The copied configuration displays in the Available Switches table under the selected switch. To
edit this configuration, refer to “Configuring an Allow/Prohibit Matrix” on page 832 or
“Configuring an Allow/Prohibit Matrix manually” on page 834.