Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

Brocade Network Advisor SAN User Manual 653
53-1002696-01
Adding target disk LUNs for encryption
20
The dialog box is used to select an initiator port when configuring multiple I/O paths to a disk
LUN. The dialog box contains the following information:
• Storage Array: Displays the storage array that was selected from the LUN view prior to
launching the wizard.
• Host: The host selected from the LUN view prior to launching the wizard.
• Initiator Port table: Lists initiator ports using the following identifiers:
• Initiator Port
• Initiator Port Name
• Initiator Node Name
• Fabric
5. Select the initiator port from the Initiator Port table, then click Next.
LUN discovery is launched and a progress bar displays. There are four possible outcomes:
- A message displays indicating no LUNs were discovered. Click OK to dismiss the message
and exit the wizard.
- A message displays indicating LUNs have been discovered, but are already configured.
Click OK to dismiss the message and exit the wizard.
- A message displays indicating that the target is not in the right state for discovering LUNs.
Click OK to dismiss the message and exit the wizard.
- The Select LUN dialog box displays (Figure 298), which lists discovered LUNs that are
available.
FIGURE 298 Select LUN dialog box
The dialog box is used to select a LUN when configuring multiple I/O paths to a disk LUN. The
dialog box contains the following information:
• Storage Array: The Storage Array selected from the LUN view prior to launching the Add
New Path wizard.
• Host: The host elected from the LUN view prior to launching the Add New Path wizard.