Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

Brocade Network Advisor SAN User Manual 481
53-1002696-01
FCoE login groups
16
FIGURE 168 FCoE Configuration dialog box
2. Perform one of the following tasks:
Under Login Group:
• Click Add to launch the Add Login Group dialog box, where you can select an existing
switch or enter the WWN of a switch on which the FCoE login group will be created. See
“Adding an FCoE login group” on page 481.
• Click Edit to launch the Edit Login Group dialog box, where you can edit the login group
parameters. See “Editing an FCoE login group” on page 483.
• Click Delete to remove the login group from the list. See “Deleting one or more FCoE login
groups” on page 484.
Adding an FCoE login group
Complete the following steps to add switches to a login group. You can manually add ports by
entering the world wide name (WWN) or select available managed CNAs from all discovered hosts.
Only directly-connected devices are supported.
1. Select Configure > FCoE from the menu bar.
or
Right-click the DCB device and select FCoE.
2. Click Add.
The Add Login Group dialog box displays, as shown in Figure 169.