Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

Brocade Network Advisor SAN User Manual 1005
53-1002696-01
Event action definitions
32
Special events handling
The following special error conditions are examples of events that are categorized as Special
Events Handling events, a separate category that appears in the Name list of the Event Actions
dialog box. All pre-selected events are SNMP traps.
• Invalid T1 zone configuration event
• 48-blade inserted into a non-Virtual Fabric chassis
• Port fencing Fabric Watch trap, when a port is fenced
• Blade Processor FPGA version is incompatible with the Fabric OS firmware version
Though these error conditions are automatically considered “special events handling” events, you
can add or edit any event action and mark the action as a special event for special events handling
using the Actions pane of the Edit Event Action dialog box.
See step 6 of “Editing event actions” on page 1003 for information on enabling special events
handling for an event using the Actions pane of the Edit Event Action dialog box.
Acknowledging special events
When the Management application receives and processes events selected as special events, the
following status bar icon displays.
1. Click the special events icon to launch the Special Events dialog box, shown in Figure 439.
The Special Events dialog box, shown in Figure 439, lists the most recent 1000 events that
have been identified as special events.
FIGURE 439 Special Events dialog box
2. Click the Acknowledged check box that corresponds to the special event you want to
acknowledge.
If an event is marked as acknowledged either in the Special Events dialog box or the Master
Log, the event is acknowledged in both places.