Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

986 Brocade Network Advisor SAN User Manual
53-1002696-01
SNMP traps
32
Adding an SNMP v3 credential
The SNMP v3 Credentials dialog box allows you to add the SNMP v3 credentials. To add an SNMP
v3 credential, complete the following steps.
1. Select Monitor > SNMP Setup > Event Reception.
The Event Reception dialog box displays.
2. Select an SNMP v3 credential from the SNMP v3 Credentials list on the Event Reception dialog
box.
3. Click Add.
The Add SNMP v3 Credentials dialog box, shown in Figure 426, displays.
FIGURE 426 Add SNMP v3 Credentials dialog box
4. Type the user name in the User Name field.
For configurations that do not have authentication or privacy, the Management application
uses the user name to match for authentication.
5. Select an authentication protocol from the Auth Protocol list. You can select -None-,
HMAC-MD5, or HMAC_SHA. HMAC_MD5 is the default.
If you select no authentication, the Management application uses the user name to match for
authentication.
6. Type a password in the Auth Password field and re-type the password in the Auth Confirm
Password field.
7. Select a privacy protocol from the Priv Protocol list. You can select -None-, CBC_DES, or
CFB_AES_128.
If you select no privacy, the Management application uses the user name to match for
authentication.
8. Type a password in the Priv Password field and re-type the password in the Confirm Priv
Password field.
9. Click OK.