Brocade Network Advisor SAN User Manual v12.0.0 (53-1002696-01, April 2013)

Brocade Network Advisor SAN User Manual 963
53-1002696-01
Adding a policy monitor
31
c. If you selected the Check for redundant connections to neighboring switches (SAN only)
check, enter the minimum number of connections allowed between a switch pair in the
Minimum Connections field.
The default recommended is 2. Valid values are from 2 through 512.
d. Select the switches or routers to which you want to apply this policy in the Available
Switches/Routers list and click the right arrow button.
NOTE
You can use the All SAN Switches targets (under the Product Groups > System Product
Groups node) in the Available Switches/Routers list) for future provisioning. Select All SAN
Switches and click the right arrow button to apply this policy to all discovered switches.
The selected switches display in the Selected Switches/Routers list.
8. To set policy monitors for hosts, select the Host Checks tab (Figure 415) and complete the
following steps.
FIGURE 415 Add Policy Monitor dialog box, Hosts Checks tab
a. Select the Check for redundant connections to attached fabrics check box to determine if
there are at least the minimum number of configured physical connections between the
host and the attached fabric.
The default is 2. For more information about this check and a fix for rule violations, refer to
“Host policy monitors” on page 955.
b. Enter the minimum number of connections between the host and the attached fabric in
the Minimum Connections field.
The default is 2.