.SAN design reference guide Vol. 1-5 785350-001

1
For current support, see the SPOCK website at http://www.hp.com/storage/spock. You must sign up for an HP Passport to enable
access.
Table 166 HP P9000 (XP) Continuous Access iFCP gateway support
NotesXP storage system
Product and minimum
supported firmware
version
XP24000
Brocade-CNT Edge
3000
• Supported switches: B-series 2/128, 2/64, 2/32, 2/16, 2800, and
2400
XP20000
Firmware: 3.1.1.3,
3.1.2, 3.1.4, 3.1.5
XP12000
XP10000
• Can be used in FCIP direct configuration
• Data compression possible
• No remote switch license required
• Maximum transmission rate from 16 Mb/s to 1 Gb/s
Contact an HP storage representative.
XP12000
Nishan IPS3300
XP10000
Contact an HP storage representative.
XP12000
Nishan IPS4300
XP10000
Table 167 HP P9000 (XP) Continuous Access ESCON IP gateway support
Minimum IP bandwidth per
path
Product and minimum supported firmware
versionConfiguration
100 Mb/s
CNT Ultranet Storage Director (USD) ESCON
HP P9000 (XP) Continuous Access ESCON over
IP
Firmware: 2.6.2-0 or 3.1
OpenVMS host-based volume shadowing
HP supports the following HP and third-party devices and features for OpenVMS host-based volume
shadowing:
• B-series1606 Extension SAN Switch and DC Dir Switch MP Extension Blade
• 400 MP Router, MP Router Blade
• B-series FC and FCIP Fastwrite
• Cisco PA-FC-1G
• C-series MDS IP Storage Services Module (IPS-4, IPS-8)
• Cisco MDS 14/2 Multiprotocol Services Module (including in MDS 9216i Fabric Channel
switch and gateway)
• Cisco MDS 18/4 Multiservice Module (including the MDS 9222i Multiservice Fabric switch
and gateway)
• C-series Write Acceleration
• CNT UltraNet 1000
• CNT UltraNet 1001
• CNT UltraNet 3000
316 SAN extension