.Part 4 SAN Extension and Bridging HP SAN Design Reference Guide 785354-001

Certified third-party WDM, iFCP, and SONET products
This section describes the following topics:
• “Certified third-party WDM products” (page 317)
Certified third-party WDM products
HP supports HP P6000 Continuous Access, HP P9000 (XP) Continuous Access, 3PAR Remote Copy,
and SVSP Synchronous Mirrors (RAID1) on all WDM products, including DWDM and CWDM,
certified by the Fibre Channel switch vendors for the equivalent HP switch models.
NOTE: SVSP Continuous Access is only supported using native Fibre Channel connectivity.
• B-series switch products—All Brocade WDM-certified products, listed by Brocade switch or
router model number, are supported. Contact an HP storage representative for the equivalent
HP switch models. See the Brocade Data Center Ready Compatibility Matrix at http://
www.brocade.com/data-center-best-practices/resource-center/index.page (select Matrices
under All Available Resources).
• C-series switch products—All Cisco WDM-certified products, listed by Cisco switch model
number, are supported. Cisco model numbers and HP model numbers are equivalent.
NOTE: HP CWDM support is based on the switch vendors' support for CWDM SFPs only. For
information about HP-supported standard (non-CWDM) SFPs, see the HP switch model QuickSpecs
or the Fibre Channel switch Streams on the SPOCK website at http://www.hp.com/storage/spock.
You must sign up for an HP Passport to enable access.
For more information about WDM technology and product support, see “Wavelength division
multiplexing” (page 261) and “WDM system architectures” (page 262).
Certified third-party WDM, iFCP, and SONET products 317