HP StorageWorks Fabric Interoperability: Merging Fabrics Based on C-Series and M-Series Fibre Channel Switches Application Notes (AA-RVH9J-TE, May 2008)

Introduction
8 Fabric Interoperability: Merging Fabrics Based on C-Series and M-Series Fibre Channel Switches Application Notes
Figure 5: Disable default zoning
Ensure Rerouting Delay is enabled
■ Launch EWS, enter the username and password, and select View/Operating Parameters
■ Verify Rerouting Delay is enabled
■ If not, select Configure/Switch/Parameters/Rerouting Delay and enable it
Figure 6: Enable Rerouting Delay