HP StorageWorks Fabric Interoperability: Merging Fabrics Based on C-Series and M-Series Fibre Channel Switches Application Notes (AA-RVH9J-TE, May 2008)

Introduction
6 Fabric Interoperability: Merging Fabrics Based on C-Series and M-Series Fibre Channel Switches Application Notes
■ Verify Active Domain ID
■ To Change the Domain ID, select the Configure Tab, the Switch Tab and then Parameters
Tab
■ In the Preferred Domain ID field, enter the Domain ID you want to use. In this example
the Domain ID is 4
Note: Select the domain IDs in the range 1-31 and this actually translates to 97-127 domain IDs in
the Interop Mode (all numbers are in decimal).
Figure 2: Launch EWS and verify and configure switch domain ID
Figure 3: Configure domain ID
Step M3: Verify switch/fabric default settings
Ensure Interop mode is set to Open Fabric: