HP StorageWorks Fabric Interoperability: Merging Fabrics Based on C-Series and M-Series Fibre Channel Switches Application Notes (AA-RVH9J-TE, May 2008)

Introduction
21Fabric Interoperability: Merging Fabrics Based on C-Series and M-Series Fibre Channel Switches Application Notes
* fcid 0x6105e1 [pwwn 21:00:00:20:37:28:22:ea]
* fcid 0x6105e2 [pwwn 21:00:00:20:37:28:2e:65]
* fcid 0x6105e4 [pwwn 21:00:00:20:37:28:26:0d]
zone name $default_zone$ vsan 1
We should see the same information from other C-series switches that are connected in the
same fabric.
Note: The below command can be used to save a copy of active zoneset in the local switch for
editing, use this command after any new zones got added into the active zoneset due to merge with
Mcdata.
MDS9509# zone copy active-zoneset full-zoneset v 1
WARNING: This command may overwrite common zones
in the full zoneset
Please enter yes to proceed.(y/n) [n]? y
MDS9509#
Verify the zones propagated properly to M-series (using EWS/HAFM)
■ Launch the EWS from your web browser
■ Select Configure and then select the Zoning Tab
■ Verify the zone set MDSCORE and zones vz1, vz2 and vz3 are properly identified
Creating zones on M-series (using EWS/HAFM)
■ Launch the EWS from your web browser
■ Select Configure and then select the Zoning Tab
■ You can create, edit and delete zones
■ You can also activate and de-activate zone sets