HP StorageWorks B-Series Remote Replication Solution Best Practices Guide (5697-6731, June 2007)

portcfg
Configures the FCIP interfaces and tunnels.
ipif:Configure IP interface entries
Usage
portcfg ipif [slot/][ge]port args
Arguments
create ipaddr netmask mtu_size
Creates IP interfaces
delete ipaddr
Deletes IP interfaces.
iproute:Confi g
ure IP route entries
Usage
portcfg iproute [slot/][ge]port args.
Arguments
create ipaddr netmask gateway_router metric
Creates IP routes.
delete ipaddr netmask
Deletes IP routes.
fciptunn el : FCI P tunnels
Usage
portcfg fciptunnel [slot/] [ge]port args [o ptional_args].
Arguments
create tunnel_id remote_ipaddr local_ipaddr comm_rate
Creates FCIP tunnels.
Optional arguments
-c
Enables compression on the tunnel specified.
-f fastwrite
Enables fastwrite on the tunnel specified. This argument
cannot be used together with -ike, -ipsec or -key (IPSec).
-ike policy
Specifies the IKE policy number used on the tunnel
specified. This argument must be used with -ipsec and
-key. This argument cannot be used togeth er with -f
(fastwrite) or -t (tape pipelining).
-ipsec policy
Specifies the IPSec policy number to be used on the
tunnel specified. This argument must be used together
with -ike and -k ey. Thisargumentcannotbeused
together with -f (fastwrite) or -t (tape pipelining).
-k timeout
Specifies the keep alive timeout, in seconds. timeout
values are 8 to 7,200; default is 10. If tape pipelining is
enabled, minimum value supported is 80.
-key preshared-key
Specifies the preshared-key to be used d uring IKE
authentication. The maximum length is 32 bytes. It must
be a double quoted string of alpha-numeric characters.
The value of this ke y must be at least 12 bytes. This
argument must be used together with -ike and -ipsec.
This argument cannot be used together with -f (fastwrite)
or -t (tape pipelin ing).
-m tim e
Specifies the minimum retransmit time, in milliseconds.
time values are 20 to 5,000; default is 100.
-n remote_wwn
Specifies the remote-side FC entity WWN.
48
Appendix: