HP StorageWorks B-Series Remote Replication Solution Best Practices Guide (5697-6731, June 2007)

4 Solu tion setup

Conﬁguring FCIP on the HP StorageWorks 400 M P Router/MP

Router blade

Use the Web Tools interface to conﬁgure the FCIP connection between two geographically

separate sites on a Wide Area Network (WAN). You ca n also use the com-

mand line i

nterface with either direct console (serial) connection to the switch or through telnet sessions (see

Conﬁguri

ng FCIP interfaces and tunnels on the HP StorageWorks 400 MP Router using CLI commands, page 47

in the App

endix.) Refer to the FOS 5.1.x (or later) administrator’s guide for additional information.

NOTE:

It is assumed that the initial switch conﬁguration setup steps a re done, including the deﬁnition of Switch

Name, IP/Subnet/Gateway (for switch management), Switch Domain ID, Time Zone, Date/Time, and so

forthforallswitchesanddirectorsinboththelocalandremotefabrics.Seethe

HP StorageWorks Fabric

OS administrator’s g uide

for speciﬁcs on setting up the switch conﬁ guration.

Follow these steps to conﬁgure FCIP on the B-Series 400 MP router.

1. Start a browser.

2. In the a ddress a rea, enter the IP address of the 400 MP Router to conﬁgure.

The switch login applet launches.

3. Enter the username and password.

The Web Tools interface displays.

4. Click ge0 on the GigE port.

The Port Administration Services window displays.

B-Series remote replication solution