Fabric OS Message Reference v7.0.0 (53-1002149-01, April 2011)

186 Fabric OS Message Reference
53-1002149-01
EM-1067
25
EM-1067
Message <timestamp>, [EM-1067], <sequence-number>,, WARNING, <system-name>, Stopping
synchronization of the system due to <version> incompatibility with standby CP.
Probable Cause Indicates that the software version on the standby CP is not compatible with this software eature
enabled on this Fabric OS firmware version.
Recommended
Action
Upgrade the software on the standby CP or disable the software feature on this CP.
To disable the ethsw service, run fosconfig --disable ethsw.
To view the buffer optimization mode for the slots run the bufopmod --showall command, and then
run the bufopmode --reset $slot command to disable the feature for those slots before
downgrading.
To disable FC8-16 serdes tuning mode, run the serdestunemode --reset command.
Severity WARNING
EM-1068
Message <timestamp>, [EM-1068], <sequence-number>, FFDC, ERROR, <system-name>, High
Availability Service Management subsystem failed to respond. A required component
is not operating.
Probable Cause Indicates that the HA subsystem has not returned a response within four minutes of the request
from the Environmental Manager. It usually indicates that some component has not started
properly or has terminated. The specific component that has failed might be indicated in other
messages or debug data. There are serious internal Fabric OS configuration or hardware problems
on the switch.
Recommended
Action
Reboot or power cycle the switch. If the message persists, collect switch information using the
supportsave command, and contact your switch service provider.
Severity ERROR
EM-1069
Message <timestamp>, [EM-1069], <sequence-number>,, INFO, <system-name>, Slot <FRU slot
number> is being powered off.
Probable Cause Indicates a blade is being intentionally powered off.
Recommended
Action
No action is required.
Severity INFO