DCFM Professional Plus User Manual (53-1001774-01, June 2010)

502 DCFM Professional Plus User Manual

53-1001774-01

8. Note Important Next Steps! below this message, and click Next.

Instructions for installing public key certificates for the encryption switch are displayed. These

instructions are specific to the key vault type. Copy or print these instructions.

FIGURE 179 Add switch to an encryption group - Next Steps dialog box

9. Click Finish to exit the Configure Switch Encryption wizard.

Replacing an encryption engine in an encryption group

To replace an encryption engine in an encryption group with another encryption engine within the

same DEK Cluster, complete the following steps.

1. From the Encryption Center, select the encryption engine, and select Engine > Replace, or right

click on the encryption engine and select Replace.

The Engine Operations tab of the Encryption Group Properties dialog box displays (Figure 180).

You can also display the Engine Operations tab by selecting an encryption group from the tree,

and selecting Group > Properties from the menu bar and selecting the Engine Operations tab,

or you can right-click the encryption group, select Properties and select the Engine Operations

tab.